Choose your country of delivery to see prices and products for your location.
Choose tax zone / country of delivery
This offer includes the original scope of delivery of the air supply unit.- Manufactured by Miessler Automotive® -By purchasing this product, the complete air supply unit, you save workshop costs in advance, or installation costs compared to the purchase with less scope of delivery.This way you avoid complications that would result from worn small parts. .Can be installed in the following vehicles:Mercedes Benz V-Class / Vito W638 (1996 - 2003)Mercedes Benz V-Class / Vito W638/2 (1996 - 2003) .Original spare part number:A6383280502, 6383280502, A638328050264, 638328050264, A6383280402, 6383280402, A6383280302, 6383280302, A6383280202, 6383280202 .Scope of delivery: OE price Compressor 850,31 EUR OE: 6383280502 Damping ring (set of parts) 15,76 EUR OE: 0004310678 Stainless steel holder 36,12 EUR OE: 6383201043 Double valve 204,44 EUR OE: 6383280530 Relay 16,86 EUR OE: 0025422619 Fuse 2,00 EUR Suction hose 5,00 EUR OE: 0004310673; 6383280212 Pressure hose 14,23 EUR OE: 6389974282 . Total 1144,22 EUR including 19% VAT. . Savings 725,22 EUR more than 50% and in addition still a higher-quality product .CAUTION: The replacement of the relay is mandatory, otherwise the warranty on the compressor is forfeited!Relay must be replaced at the same time as the compressor change .Before purchasing a compressor, please note the following: The most common reason for a defective compressor is a leak in the system, causing the compressor to run too long and too often.An excessive number of switch-on cycles will cause the relay contacts to stick together. As a result, the relay no longer functions.The result is continuous current on the compressor.The compressor runs continuously without control until it burns out.Before a new compressor is installed, all the reasons why it has been damaged must be completely eliminated. .The leak:A leak can occur in many places, such as- Porous or damaged air springs- Worn seals, defective compressed air connections and chafed compressed air hoses- Leaky components such as compressors, valves and air springs..Every air spring system is vulnerable in this way.Therefore, follow our advice to avoid any further repairs in the near future..Basic advantages why you are in good hands with Miessler Automotive® when it comes to air suspension:- We have been dealing with this topic since 2003- Manufacturer selected by us is one of the supporting pillars for best quality- Close cooperation with manufacturers in the field of quality management- More and more own products that facilitate the repair of your vehicle- Repair service in our own specialist car workshop..Our technical advice for the air supply device:1. Change the relays before installing the compressor even if it seems to still work. This is also a specification by the car manufacturer. Be sure to change the right relays. Relays look similar, that is why there is a risk to change the wrong relays.2. Be sure to check whether the system is leakproof after repairing.The easiest way to do this is to park the vehicle. Wait for the system to automatically re-adjust if your car has this feature.Then measure the heights from the ground to the lower edge of the fender as exactly as possible and take notes. On the day after measure these heights again and compare them with the ones before. Even a small difference will lead to a damaged compressor and damaged valves in the long run..When driving with a leaking suspension for a long time it needs to be assumed that the compressor is running more often than normal. The increased number of cycles of powering on and off is likely to already have damaged the compressor. Depending on the duration of that condition you should change the relays and check the performance of the compressor to be on the safe side. After the vehicle stood overnight the compressor normally doesn't need to run more than 20 to 30 seconds for the system to be ready to start.
There are no reviews yet.
