This control valve block 68087233AA for the air suspension of the JEEP Grand Cherokee WK2 comes from the same production line as the original Jeep valve.
Miessler Automotive® is the only place where you can get this Made in Germany Air Suspension Control Valve with the same OEM quality & specifications.
If you don't want to compromise on quality & reliability, then Miessler Automotive Germany is your only aftermarket source for quality and reliable Air Suspension Control Valves.
DRIVING SAFETY, DAMPING POWER, FUEL CONSUMPTION
In your vehicle the integration of Air Suspension Systems, regulated damping, roll stabilization and other active suspension systems is becoming increasingly important.
Pneumatic and hydraulic valves are in use at key points of the chassis and ensure a smooth operation.
Can be installed in the following vehicles:
Jeep Grand Cherokee IV WK, WK2 (2011-2020)
JEEP GRAND CHEROKEE Limited (2011-2018)
JEEP GRAND CHEROKEE Overland (2011-2018)
JEEP GRAND CHEROKEE Summit (2014-2018)
JEEP GRAND CHEROKEE Laredo (2011-2018)
JEEP GRAND CHEROKEE Trailhawk (2017-2018)
JEEP GRAND CHEROKEE Hemi SRT V8 (2015-2018)
JEEP GRAND CHEROKEE Hemi SRT8 V8 (2012-2014)
Valve replaced with the spare part numbers:
Original OEM RAPA valve
Before using your old pressure hose, cut 5mm with the supplied hose cutter tool.
Use only the new connector that is already on the spare part. Push the presssure hose as far as it will go.
This will ensure a perfect seal.
The vehicle suspension system is based on a combination of electronic level control and nitrogen 5 or CO2 filled air springs.
After replacement of any spare parts, such as compressor, air spring, valve and / or strut, the output pressure in the system MUST have 17 bar.
A compressor can only partially compensate for the pressure difference.
You MUST follow the appropriate car manufacturer's installation instructions.
If the appropriate car manufacturer's installation instructions and specifications are not followed correctly, your system will continue to show errors or will malfunction.
If our parts are damaged in the process if will void any warranty or guarantee.
Normally the complete emptying of the system is required under car manufacturer's installation instructions .
After replacement of the corresponding spare part, the system MUST be recharged with CO2 or nitrogen 5 in accordance with the requirements of the car manufacturer.
This can only be done with appropriate software and appropriate special tools.
After this procedure, you can start further steps, such as calibration of the vehicle's suspension leveling control system.
-Made in Germany
-Much cheaper than authorized repair
-We as German provider have the European returns policy
-We also have a 2 years warranty
-Worldwide express delivery is our standard
-In Europe we have the longest experience with the topic of air suspension for automobiles in the after market.
Installation and expansion may only be carried out by trained personnel in a specialist workshop. Also note our installation instructions.
There are no reviews in the current language.